MP1001 Series Magnetic Position Sensors on Marsh Electronics, Inc.

Printable Page Email

Email This Page

Save To Favorites


	MP1001 Series Magnetic Position Sensors
	Check up to five results to perform an action.

	Solid state, magnetic position sensors with electrical immunity protection. Features Stable output over operating temperature range Compatible with unregulated power Supply Reverse battery protected to -24VDC Internal circuit protection to IEC529 1000 -EMI resistant to 10V/m, 30MHz to 1GHz -ESD resistant to 4kV (contact discharge) -Fast transient resistant to 2kV -Conducted immunity resistant 10VRMS®150kHz to 80MHz -EMC compatible 30A/m®50Hz Meets IEC529 IP67 for dust and water protection South pole activated Open collector (sinking or NPN) output can be used with bipolar or cmos logic circuits with suitable pull up resistor -Output switches low (off) when the magnetic field at the sensor exceeds the operate point threshold -Output switches high (on) when the magnetic field is reduced to below the release point threshold RoHS Compliant Applications: Safety door Power sliding door Flow sensing Note: These sensors require the use of an external pull-up resistor, the value of which is dependent on the supply voltage. Pull-up resistor should be connected between output (Black) and Vcc (Brown).
	larger image	larger image